ASEAN Trade Repository
ISO 1436:2009 specifies requirements for six types of wire-braid-reinforced hose and hose assembly of nominal size from 5 to 51 plus, for one of the… [More Details+]
ISO 8030:2014 specifies a method for assessing the flammability of hoses, except for hoses intended for use with petroleum fuels for combustion engines. The method… [More Details+]
ISO 8331:2014 sets out recommendations designed to maintain rubber and plastics hoses and hose assemblies, prior to use, in a condition as close as possible… [More Details+]
ISO 8308:2006 specifies two methods for the determination of transmission of liquids through hose and tubing walls. Both methods are applicable to rubber and plastics… [More Details+]
ISO 4642-1:2009 specifies the requirements and test methods for semi-rigid reel hoses for fire-fighting purposes for use with fixed systems. The hoses are intended for… [More Details+]
ISO 4642-2:2009 specifies the requirements and test methods for semi-rigid reel hoses for use on fire fighting vehicles and trailer pumps. The hoses are intended… [More Details+]
ISO 4079:2009 specifies requirements for five types of textile-reinforced hydraulic hose and hose assembly of nominal size from 5 to 100. They are suitable for… [More Details+]
Specifies requirements for five types of hose and hose assembly used in automobile power-steering systems, the five types differing in their pressure ratings and volumetric… [More Details+]
ISO 8789:2009 specifies the requirements for rubber hoses and hose assemblies, up to a maximum hose size of 19, for use in motor vehicles with… [More Details+]
This International Standard specifies the requirements for three types of rubber hose and hose assembly used for measured fuel dispensing, including oxygenated fuels (up to… [More Details+]
ISO 4641:2010 specifies the minimum requirements for textile-reinforced, smooth-bore rubber water-suction and discharge hoses and hose assemblies. Three types of hoses and hose assemblies are… [More Details+]
Specifies requirements for vulcanized-rubber hoses and tubing for use in the various air and vacuum systems found on internal-combustion engines. Does not cover hoses used… [More Details+]
ISO 4081:2010 specifies the requirements for straight or pre-formed rubber hoses and tubing for use in pressurized or unpressurized cooling circuits containing 1,2-ethanediol-based coolants in… [More Details+]
ISO 2398:2006 specifies the requirements for three types, three classes and two categories of textile-reinforced rubber hose for compressed air, up to a maximum working… [More Details+]
ISO 1403:2005 specifies the requirements for three types of general-purpose textile-reinforced rubber water hose with an operating temperature range of -25 °C to +70 °C… [More Details+]
ISO 6803:2008 describes hose impulse testing, without flexing, of rubber or plastics hydraulic hose assemblies at both high and low impulse pressures. The high-pressure testing… [More Details+]