Search Harmonised Standards in ASEAN: ASEAN BODY

Broadleaved wood raw parquet blocks — General characteristics / ISO 3397:1977

Lays down manufacturing characteristics and dimensions, permissible deviations, methods for quality control and delivery conditions, measurement and marking assisted by tables and examples.  [More Details+]

Furniture — Tests for surface finishes Part 2: Assessment of resistance to wet heat / ISO 4211-2:2013

specifies a method for the assessment of the resistance to wet heat of all rigid furniture surfaces regardless of materials. It does not apply to…  [More Details+]

Furniture — Tests for surface finishes Part 3: Assessment of resistance to dry heat / ISO 4211-3:2013

ISO 4211-3:2013 specifies a method for the assessment of the resistance to dry heat of all rigid furniture surfaces regardless of materials. It does not…  [More Details+]

ISO 2426-3:2000 Edition 1 Plywood — Classification by surface appearance / ISO 2426-3:2000 Edition 1

This part of ISO 2426 specifies the nature and limits of characteristics inherent in wood and manufacturing defects enabling the visual assessment of the plywood…  [More Details+]

Mosaic parquet panels -- General characteristics / ISO 631:1975

These panels of any species of wood are assemblies made from wood fingers of a parallelepiped rectangular shape, forming component squares laid in a chequered…  [More Details+]

Sawn timber — Test methods — Determination of resistance to local transverse compression / ISO 8906:1988

This method is based on the load proportional limit and the load at a defined deformation which are given in the "load/deflection" curve. Stresses at…  [More Details+]

Sawn timber — Test methods — Determination of ultimate strength in shearing parallel to grain / ISO 8905:1988

This International Standard specifies a method of testing sawn timber of coniferous and broadleaved species in shearing parallel to the grain to determine the ultimate…  [More Details+]

Solid wood parquet -- Classification of beech strips / ISO 2457:1976

Divides non-assembled strips into two quality grades that are identified by (+++) and (++) corresponding to the conditions specified in the tables. The regulations for…  [More Details+]

Solid wood parquet — Classification of beech strips / ISO 2457:1976

Divides non-assembled strips into two quality grades that are identified by (+++) and (++) corresponding to the conditions specified in the tables. The regulations for…  [More Details+]

Solid wood parquet — Classification of fir and spruce strips / ISO 5320:1980

Divides the blocks by quality into the three grades (+++), (++), and (+) corresponding to the conditions stated in the tables. Refers to a protection…  [More Details+]

Solid wood paving blocks — General characteristics / ISO 5327:1978

Specifies manufacture, dimensions, tolerances and the inspection and delivery conditions and marking. The common and special shapes are shown in figures. Applies to blocks used…  [More Details+]

Solid wood paving blocks — Hardwood paving blocks — Quality requirements / ISO 5326:1978

Applies to paving used for covered (indoor) and open (outdoor) spaces. Blocks made of Fagus sylvatica wood are intended for use in covered spaces only.…  [More Details+]

Solid wood paving blocks — Softwood paving blocks — Quality requirements / ISO 5328:1978

Applies to paving used for covered (indoor) and open (outdoor) spaces. The permissible wood or sawing defects and corresponding acceptance conditions are listed in a…  [More Details+]

Wood for manufacture of wood flooring — Symbols for marking according to species / ISO 2036:1976

These symbols are composed of four adjoining capital letters, not separated by points and not followed by a full stop. The letter X as the…  [More Details+]